Automatic Vacuum Feeding Machine Pneumatic Feeder for Continuous Powder Conveying

Automatic Vacuum Feeding Machine Pneumatic Feeder for Continuous Powder Conveying

Model: Feeder-type

Review

Description

Automatic Vacuum Feeding Machine Pneumatic Feeder for Powder Granule Transfer materials

Never block vacuum feeder

1. We are continuous feeding: the market is intermittent cutting. There is a valve next to the vacuum feeder on the market. The vacuum is pumped out. After the timing is set to the time, it will open-discharge-when the pump is closed. It is intermittent, so its output is not as large as ours. At best, it can feed 10 to 20 kilograms of material in 1 minute. Our small model can do 30kg to 50kg per minute in one minute, which is equal to 1 hour and 3 tons of material.

2. Our filtration is different: the vacuum feeder on the market is a filter element, it is easy to cause the phenomenon of material blockage, take it out for cleaning, and more serious is that some customers have to clean every 2 hours at home, or there is humidity It is easy to block the material, and then our filter element is not used, it is also an unused filter bag, or a cloth bag. We use a "sintered plate". So far, the sintered plate is unique in gas-solid separation. So far, the filtration accuracy is 0.1 micron in this industry. What is the concept? The filter cartridges and cloth bags we usually use are 1 micron and 0.1 microns, which is equivalent to 10 times the filtration accuracy of the filter cartridges and cloth bags.

3. Easy to wash with water: This set of equipment can be disassembled and washed with water. What's more convenient is that you can install it after washing, the fan starts, and it will be clean after running for a few minutes.

4. Easy and detachable: Our set of products are mainly for powders, additives, and use. In general, the amount of powder, additives, and other additives is not very large, and the specifications are often changed. It is necessary to clean up the tank and equipment pipes. Our equipment is easier to disassemble and clean.

5. No dust: Because our equipment is directly connected to the tank and it is airtight, so there will be no leakage during all the feeding process.

6. Simple operation: we installed all the control systems in an explosion-proof motor cabinet for centralized control

Manufacturing details

7. One-key cleaning: When some materials are stuck on the filter element, one-key open the cleaning device, automatic external back-blowing cleaning

8. One-key frequency conversion: The feeding speed can be adjusted at any time, with knob type, fast or slow, fool-like operation.

9. The whole machine is explosion-proof: the whole machine is made according to the national explosion-proof grade

10. Vibratory hammer attached: a vibration hammer is installed on the vertebral part of the cylinder body so that the material can easily fall into the reactor

12. Increase the access door: we have a safe access door in the cylinder body to avoid the overall disassembly when maintenance is needed

13. High temperature automatic spraying: A temperature sensor is installed inside. When a certain temperature is reached, the internal automatic spraying and spraying will start, and the explosion relief valve will open at the same time

14. Explosion relief valve: In response to the requirements of the current environmental safety assessment, the safety of equipment has been improved, and explosion relief valves have been added to improve safety performance

Video